 Instruction book Audi A4 Version Year 2017/div> Show Electro-mechanical power steering assists the driver when steering. The degree of power assistance is adapted electronically, depending on the speed. Warning/indicator lamps and driver messages
If the warning lamp lights up permanently and the message appears, there may be a power steering failure. Stop the vehicle in a safe place as soon as possible. Do NOT drive on. Obtain professional assistance.
If the indicator lamp lights up and the message appears, the steering response may be heavier or lighter than usual. In addition, it is possible that the steering wheel will be off centre when driving in a straight line. Drive slowly to a qualified workshop and have the fault rectified.
If the indicator lamp lights up and the message appears, the dynamic steering* is being initialised. The steering wheel will move slightly after the engine is started. This may occur if the steering wheel was moved while the engine was off. The indicator lamp will go out when the initialisation has been completed. Note
All images, logos and text are property of © Audi. This site has no relationship with the company Volkswagen - Audi Spain nor any of its affiliates worldwide. For more information. To contact the author of this website click here. This article show you guide on how to use Launch X431 PAD V to repair Audi A4 2013 steering system fault B116854 & C10ACF0 trouble code.It need perform steering angle sensor learning.For Audi repair,please check more cases here:Audi Trouble Repair Projects. Trouble Code: B116854:Steering Angle Sensor-No Basic Setting C10ACF0:Steering-End Stops Not Learned Connect Launch X431 PAD V to Audi A4 and then select “Audi” Select “Guided Functions” Select “Audi A4 2008>”–>2013(D)–>Sedan–>CADA 2.0I TFSI/155kW Press “Confirm” System Selection–>Assistance–>Power Steering–>G85-Steering Angle Sensor,Calibration In this program the following test steps will be performed: Calibration of G85-Steering Angle Sensor Checking DTC Memory of Power steering control Module-J500 Checking DTC Memory of Steering Column Electronic Systems Control Module-J527 Required Auxiliary Equipment: 6485 Steering Wheel Level Note:The Launch X431 PAD V system will guide you step-by-step Click “Complete/Continue” Connect the battery charger to the vehicle Switch ignition on Press “Complete/Continue” Please Check DTC Memory: The DTC Memory of the power steering control module-J500 Store No Malfunction requiring a calibration. Click “YES” Drive a short distance.Play the steering free play and keep the steering straight ahead. The Zero Position Of G85-Steering Angle Sensor is OK Then clear DTCs. More Launch X431 Training article,please check here:Launch X431 user guide (Visited 340 times, 3 visits today) Is it safe to drive with power steering light on?Is it Dangerous to Drive With My Power Steering Light On? Although it is possible to drive when the power steering light is on, the car might be much harder to drive, especially if the warning light has been accompanied by a total loss of power steering.
What causes electric steering failure?Today's electronic power steering systems may fail due to issues with the mounted electric motor. In particular, excessive heat on the motor is likely to cause the failure modes. Infiltration of the system environment by water, dirt, or other contaminants will also likely lead to EPS failure.
How much does it cost to fix the power steering assist fault?How much does it cost to fix the power steering assist fault? You can expect to pay between $0 and $1000 to fix the power steering assist fault, but there is no fixed cost. If you're lucky, you can fix it by replacing a fuse or adding power steering fluid which can cost you under $10.
|
Audi steering system fault you can continue driving
Related Posts
Copyright © 2024 ihoctot Inc.
